I just setup my domain how do i create email accounts?

Using the login information sent to you in the Account Activation email: Log into the Control Panel
Click on the domain you want to setup email accounts for
Click the Domains shortcut in the navigation pane.
Click the required domain name in the list.
Click Mail in the Services group.
Click Add New Mail Name.
Your domain name is shown to the right of @ sign, so you only need to specify the desired name for the mailbox.
This can be, for example, user's first name and last name separated by a dot, a department name, or any other text in Latin symbols. The name should be short enough to remember. It can comprise alphanumeric, dash dot and underscore symbols.
Specify a password that mailbox owner will use for accessing his or her mailbox.
Make sure that a check mark is present in the Mailbox check box.
If required, limit the amount of disk space that this mailbox can use. To do this, under Mailbox quota select the Enter size option and type the desired value in kilobytes.
To allow the mailbox owner to manage his or her mailbox through a mailbox administration panel, select the Control panel access check box and specify the language for the user's control panel.
To allow the mailbox owner configure and use spam filter and antivirus, click Permissions, select the respective check boxes and click OK.
Click OK

How To Set Up POP3 Access To An E-mailbox (outlook.Eudora…)
In Microsoft Outlook, select Tools > E-mail Accounts
On the E-mail Accounts wizard window, select "Add a new e-mail account" and click Next.
For your server type, select "POP3" and click Next.
On the Internet E-mail Settings (POP3) window, enter your information as follows:
Your Name
Enter your first and last name.
E-mail Address
Enter your e-mail address.
User Name
Enter your e-mail address, again. *Note- you must enter complete email address
Password
Enter password
Incoming mail server (POP3)
Your incoming server is mail.yourdomain.com
Outgoing mail server (SMTP)
Enter smtp.yourdomain.com or the outgoing server setting specified by your ISP (e.g., if you use COX residential, your outgoing server setting might be smtp.west.cox.net) you will need to call your ISP for their outgoing mail server
Click "More Settings."
On the Internet E-mail Settings window, select the "Outgoing Server" tab.
Select "My outgoing server (SMTP) requires authentication."
Select "Use same settings as my incoming mail server".
Click OK
You can click “Test Account Settings.. “ to test new settings
Click Next
Click Finish

Was this answer helpful?

 Print this Article

Also Read

When downloading emails in Outlook, it gets stuck and does not finish?

Sounds like you have been sent a dodgy email that confuses Outlook. Please login to your mailbox...

I think I setup my mail accounts correctly, but Outlook says: There was a problem logging onto your mail server. Your username or password was rejected

First confirm that you are using the correct password and check to make sure that the username...

I am receiving a lot of spam messages what can I do?

There are many ways that spammers harvest and collect email addresses tobuild their lists. The...

Do you provide IMAP4 access to e-mail?

We do provide IMAP4 access to e-mail. IMAP4 stands for Internet Message Access Protocol version...

I get bounced emails from your server when i send messages through my domain

Please enable SMTP authentication following instructions below, select the appropriate mail...